Kapa KN15-16 20 HP Rotary Screw Air Compressor for Fiber Laser Cutting – 232 PSI w/ Dryer & 120 Gal Tank (Showroom Demo)

Kapa KN15-16 20 HP Laser Air Compressor – 232 PSI

Showroom Demo · In Stock in Pomona, CA · Ready to Load

Running a fiber laser? Air cutting can replace nitrogen on a lot of thin mild steel, stainless and aluminum work, as long as the air shows up at the nozzle dry, clean and at pressure. A standard 125 psi shop compressor won't get you there.

The Kapa KN15-16 is built for laser air. It puts a 20 HP rotary screw compressor, a refrigerated dryer and a 120-gallon ASME tank on one skid, rated 232 psi (16 bar). You hook up one power drop and one air line, and you're cutting.

This unit ran as part of our showroom laser air setup. It's on our floor in Pomona now, so you skip the roughly 7-week factory lead time on a new one.

What's on the Skid

• 20 HP (15 kW) rotary screw compressor, rated 232 psi / 16 bar
• Refrigerated air dryer, mounted and plumbed
• 120-gallon ASME-stamped receiver tank (U stamp, rated 1.6 MPa / 232 psi)
• Touchscreen controller with emergency stop
• Fully enclosed cabinet on a base with fork pockets

Specifications

Who It's For

• Fiber laser shops switching thin-gauge work from nitrogen to air cutting
• Shops adding a new laser that need a complete air package, not just a compressor
• Fabricators who need 150+ psi air for other high-pressure tools

Is It Enough Air for Your Laser?

Air demand depends on laser power, nozzle size and material. Send us your laser model and nozzle size and we'll tell you whether this unit covers it before you buy.

See It Before You Buy

It's on our showroom floor at 3695 E. Pomona Blvd., Pomona, CA 91768. Pickup in Pomona, or we'll quote freight to your door.