New 26"/35" x 120" Acra Precision Gap Bed Engine Lathe (12 Speeds)

Acra’s 26120ACH Precision Gap Bed Engine Lathes are made in Taiwan and features the following:

Bed

• Made of Meehanite cast iron which relieves vibration stress
• Induction hardened (HS70 Degree) and precision ground 
• Precision hand scrapped removable gap 
• Foot brake

Universal Gear Box

• Oil bath lubrication
• Heat treated gears
• Inch/metric/module/diametrical threads
• Output shaft is designed with safety pin 

Apron and Saddle

• Manual and automatic lubrication system-oil distributor adjusted to lubricating bed ways and cross side or both.
• Overload protection device
• Cross slide is hardened and precision ground
• Cross slide screws are hardened and oil bathed
• Forward-Off-Reverse lever
• Top and saddle slide locking system
• T-Slot compound

Spindle

• Supported by 3 precision P-Grade taper roller bearings.
• Dynamically balanced, hardened and precision ground
• D1-11 Spindle Nose, Spindle Hole 4-1/16″

Headstock

• All gears made by chromium molybdenum steel and segmentation treated and precision ground. 
• Forced lubrication system 

Tailstock

• Quill made by chromium molybdenum steel with segmentation and precision ground.
• Diameter Tail Stock Spindle 2.935″ and Spindle Travel 7″
• Two speeds with 1:1 and 1/4:1 change feeds

Specifications:

• Capacity:  26″/35″ x 120″
• Swing Over Bed: 26″
• Swing Over Cross Slide: 17-1/2″
• Swing In Gap: 35-1/8″
• Distance Between Centers: 120″
• Bed Width: 15-3/4″

Headstock

• Spindle Nose: D1-11
• Spindle Bore: 4-1/16″
• Taper of Spindle: MT No. 7 x MT No. 5
• Spindle Speeds – Steps: 12
• Spindle Speeds – Range: 13 ~ 1,200 RPM

Carriage

• Cross Slide Travel: 15-3/4″
• Compound Slide Travel: 9-1/2″

Threads & Feeds

• Inch Threads: 2 ~ 72 TPI
• Metric Threads: 0.2 ~ 14 mm
• Longitudinal Feeds: 0.0012 ~ 0.039 in/rev
• Cross Feeds: 0.0004 ~ 0.0117 in/rev

Tailstock

• Quill Diameter: 2.935″
• Quill Travel: 7″
• Quill Taper: MT No. 5

Power

• Spindle Drive Motor: 15 H.P./4P
• Voltage: 230 or 460V AC/3 PH

Standard Equipment

• Main Motor 15 HP
• Center Sleeve MT No. 5
• Dead Center MT No. 5 X 2 PCs
• Leveling Screw and Block
• Service Kits and Toll Box 
• Steady Rest: 1-5/8″~10″
• Drive Plate: 12″ for D1-11 only
• Coolant System
• Multi– Position Length Stop 
• 3 Jaw Scroll Chuck: 15″
• Full Length Splash Guard 
• Halogen Light 
• 4 Way Tool Holder